CBDSJ - RX:6R372, 5318/5320/5322/5340/5343/5343-(SUPDAT)
- MSDS: CBDSJ
- Manufacturer: XEROX CORP
- Product Name: RX:6R372, 5318/5320/5322/5340/5343/5343-(SUPDAT)
- National Stock Number: 7510-00N066559
Product Identification
Product ID:RX:6R372, 5318/5320/5322/5340/5343/5343-(SUPDAT)
MSDS Date:11/16/1994
FSC:7510
NIIN:00N066559
MSDS Number: CBDSJ
Responsible Party
ROCHESTER, NY 14644
US
Emergency Phone: 716-422-2177/416-422-1230
Info Phone: 800-828-6571
Cage: 0E6G9
Contractor
Telephone: 800-828-6571/716-422-2177
Cage: 26921
Ingredients
ACRYLIC ACID BUTYL ESTER POLYMER WITH STYRENE
CAS: 25767-47-9
Fraction By Weight: 80-90%
OSHA PEL N/K
ACGIH TLV: N/K
C.I. PIGMENT YELLOW 97,
CAS: 12225-18-2
Fraction By Weight: 5-10%
OSHA PEL N/K
ACGIH TLV: N/K
PROPENE POLYMERS; (POLYPROPYLENE)
CAS: 9003-07-4
RTECS: UD1842000
Fraction By Weight: 5-10%
OSHA PEL N/K
ACGIH TLV: N/K
TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 1-3%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
COPPER, (PHTHALOCYANINATO(2-))-; (BLUE PIGMENT)
CAS: 147-14-8
RTECS: GL8510000
Fraction By Weight: 1-3%
OSHA PEL N/K
ACGIH TLV: N/K
RESIDUE CAN BE REMOVED W/SOAP & COLD WATER. GARMENTS
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:LD50:(ORAL,RAT) >5 G/KG
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:MINIMAL RESPIRATORY TRACT
IRRITATION MAY OCCUR AS WITH EXPOSURE TO LARGE AMOUNTS OF ANY
NON-TOXIC DUST. IN A XEROX SPONSORED CHRONIC INHAL STUDY IN RATS
USING A SPEC TEST TONER, THERE WERE NO LU NG CHANGES AT ALL IN
LOWEST EXPOS LEV (1 MG/M3), THE MOST RELEVANT LEV TO POTNTL HUMAN
EXPOSURES. A (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:VERY SLIGHT DEGREE OF FIBROSIS WAS
NOTED IN 25% OF ANIMALS AT MIDDLE EXPOS LEV (4MG/M3) WHILE A SLIGHT
DEGREE OF FIBROSIS WAS OBSERVED AT HIGHEST EXPOS LEV (16 MG/M3) IN
ALL ANIMALS. THESE FI NDINGS ARE ATTRIBUTED TO "LUNG OVERLOADING" A
GENERIC RESPONSE TO EXCESS AMTS OF ANY DUST RETAINED IN THE LUNGS
(SUPDAT)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:EYES:FLUSH WITH WATER FOR @ LEAST 15 MINS. SKIN:WASH WITH
SOAP & WATER. INHAL:REMOVE FROM EXPOSURE. INGEST:DILUTE STOMACH
CONTENTS WITH SEVERAL GLASSES OF WATER.
Fire Fighting
Extinguishing Media:WATER, DRY CHEMICAL, CARBON DIOXIDE OR FOAM.
Fire Fighting Procedures:AVOID INHALATION OF SMOKE. USE NIOSH/MSHA
APPROVED SCBA & FULL PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:TONER IS A COMBUSTIBLE POWDER. LIKE MOST
ORGANIC MATERIALS IN POWDER FORM, WHEN DISPERSED IN AIR, IT CAN
FORM EXPLOSIVE MIXTURES.
Accidental Release
Spill Release Procedures:SWEEP UP/VACUUM SPILLED TONER & CAREFULLY
TRANSFER INTO SEALABLE WASTE CNTNR. SWEEP SLOWLY TO MIN GENERATION
OF DUST DURING CLEAN-UP. IF VACUUM IS USED, THE MOTOR MUST BE RATED
AS DUST TIGHT. A CONDUC TIVE HOSE BONDED TO THE MACHINE SHOULD BE
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:USE WITH ADEQUATE VENTILATION.
Other Precautions:AVOID PROLONGED INHALATION OF EXCESSIVE DUST.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:NONE REQUIRED WHEN USED AS INTENDED IN MFR EQUIPMENT.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EMERGENCY EYE WASH & DELUGE
SHOWER .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR TRADE NAME/PART NO:C/5350/5352/5352-C GREEN DRY INK. EFTS OF
OVEREXP:FOR A PRLNGD INTERVAL. THE SPEC TEST TONER WAS 10 TIMES
MORE RESPIRABLE THAN COMMERCIALLY AVAIL MFR TONER TO COMPLY W/EPA
TESTI NG PROTOCOL & WOULD NOT FUNC PROPERLY IN MFR EQUIP. SPILL
RELEASE:USED TO REDUCE STATIC BUILDUP (SEE SECTION V). (ING 6)
Chemical Properties
Spec Gravity:1 (H*2O=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:GREEN POWDER/FAINT ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:PRODUCTS OF COMBUSTION MAY BE TOXIC.
AVOID BREATHING SMOKE.
Disposal
Waste Disposal Methods:WHEN DISPOSED, THIS MATL IS NOT A HAZ WASTE
ACCORDING TO FED REG 40 CF4 261. HOWEVER, STATE & LOCAL
REQUIREMENTS MAY BE MORE RESTRICTIVE. THEREFORE, CONSULTATION
W/APPROP FED, STATE & LOCAL WASTE DISP AUTH IS ADVISED. INCIN ONLY
IN CLSD CNTNR.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.